...
Diameter Measurement with Laser Cameras
Version 2.2
Date: 27.10.2022
...
Hitting the button Parallel-Laser in the OSD panel is going to set the camera to the READY mode.
| Info |
|---|
In case of working with an iPEK camera system the user will have to push the corresponding start button on the iPEK control unit. This is going to activate the laser dots, the camera head automatically rotates and the picture luminosity is reduced to 0%. |
In case of working with camera systems from RICO or RIEZLER please contact the corresponding manufacturer for the required hardware control steps.
...
Make sure the camera is switched on and hit the button Parallel-Laser in the OSD-Panel to launch the measurement:
...
Click on the button SETUP in the status dialogue, select the camera type (1) and the specific configuration (2) used for the measurement:
...
The message Too many spots will warn you immediately if ever the image is too bright and the laser dots are not flashing up distinctly.
...
Once the light is switched off and the image is dark enough the text Waiting (2) will be displayed otherwise the text Waiting (1) is shown:
...
The laser dots are now flashing up and the camera head starts rotating. During the rotation a GREEN circle line is constantly drawn by the laser dots:
Finally the result is displayed in a separate dialogue and looks as follows:
...
The button Save Picture allows the user to save the displayed result as a picture in the JPEG format.
...