Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Table of Contents
minLevel1
maxLevel4
exclude(Page Contents|Abstract|Author).*

...

Introduction

This page is intended to describe a temporary solution to data validation pending software updates in WinCan VX. This solution can be used in any version build of WinCan VX.

...

When the tool is executed, it will validate all objects in the database and give an error report and must be explicitly launched by the user, but in a future release, this will launch automatically when a user starts the 3D Measurement process and will only validate the currently selected section or lateral where the user wishes to make a measurement.

...

Setup

This step is only needed in WinCan VX v14.2 or lower.

  1. With WinCan VX closed, navigate to C:\Users\Public\Documents\CDLAB\Common\DataValidator

  2. Unzip the attached file and place the contents inside the folder.

  3. Launch WinCan VX and open a project.

View file
nameVX 3D

...

Data Validators.zip

The validation rule files here are currently only for the German market.

...

Using the Data Validator

The Data Validator in WinCan VX must be activated by the user every time they wish to use it, and also on laterals and sections. To launch the tool, click either of these two buttons:

...