...
Abstract
How to ensure the best possible results from 3D measurement equipment with WinCan VX
Author
Steve Peregrine BEng Hons, Senior Technical Manager
...
Page Contents
| Table of Contents | ||||||
|---|---|---|---|---|---|---|
|
...
Introduction
This page is intended to describe a temporary solution to data validation pending software updates in WinCan VX. This solution can be used in any version build of WinCan VX.
...
When the tool is executed, it will validate all objects in the database and give an error report and must be explicitly launched by the user, but in a future release, this will launch automatically when a user starts the 3D Measurement process and will only validate the currently selected section or lateral where the user wishes to make a measurement.
...
Setup
This step is only needed in WinCan VX v14.2 or lower.
With WinCan VX closed, navigate to C:\Users\Public\Documents\CDLAB\Common\DataValidator
Unzip the attached file and place the contents inside the folder.
Launch WinCan VX and open a project.
| View file | ||
|---|---|---|
|
...
|
The validation rule files here are currently only for the German market.
...
Using the Data Validator
The Data Validator in WinCan VX must be activated by the user every time they wish to use it, and also on laterals and sections. To launch the tool, click either of these two buttons:
...