Back to Inspection Merging
Chapters
Data Review
The inspection list for the currently selected asset always shows the individual inspections attached to this asset, with some rudimentary information about the inspection length, date, time, inspection direction and most usefully if the inspection was completed or abandoned:
Figure 6: Inspection records review below the section grid.
After combining, we would normally expect to see at least one abandoned inspection from each end (the golden rule), and the combined inspection (see the different small icon on the left hand side) which will either be marked as complete or abandoned based on whether or not the whole pipe has been inspected.
Clicking on any of these lines will focus the observation grid and the pipe graph on the selected inspection record. Notice that the date and time of the combined inspection is the same as the date and time of the most recent inspection that was used in the merge. This is standard process.
These inspection records are also visible and can be managed (new ones added or deleted) inside the section header, so opening the header and looking in the bottom-right corner will reveal the same list:
Figure 7: Inspection records review in the section header.
The significant difference with this list is the buttons in the very lower right corner which can be used here to delete inspections or add new ones. These options are not available in the main screen view panel of the inspections.