PearPoint P350; Instructions for setting up device

Configure the PP350 IP address:

  1. Without network cable plugged in Turn on the PP350

  2. Press OK

  3. Press F1 (Setup)

  4. Press F3 (Comms)

  5. Press F2 (Eth)

  6. Set the boot type to STATIC IP (toggle using OK button)

  7. Set the IP ADDRESS EG: 192.168.1.34 using the Keyboard or combination of arrow keys and OK buttons. Take note of IP address of unit

  8. Set up SUBNET usually 255.255.255.0

  9. Leave GATEWAY blank

  10. Turn OFF PP350

Configure the WinCan computer IP address

Proceed as follows to turn off windows firewall

1.) Type firewall in Windows search:

2.) Load Windows Defender Firewall:

3.) Activate the corresponding option buttons to turn off Windows Defender Firewall:

4.) Search in the Windows Bar – “View Network Connections” & press ENTER:

Right Click PROPERTIES on the Network Adapter that the PP350 camera is connected too.

1.) Look for the entry Internet Protocol Version 4 (TCP/IPv4) and click PROPERTIES:

2.) Select the option Use the following IP address and fill in the following information:

IP address: 192.168.1.34

Subnet Mask: 255.255.255.0

Default Gateway: 192.168.1.1

3.) Select the option Use the following server addresses and fill in the following information:

Preferred DNS server: 8.8.8.8

Alternate DNS server: 8.8.4.4

Configure PP350 within WinCanVX

Open Wincan VX and go to Home > Settings:

  • Move to the category OSD (1), select the device Pearpoint-P350 from the list (2) and hit the settings cog (3)

  • Check whether the IP-address (4) is set correctly: 192.168.1.34

  • Confirm all settings hitting the green OK-button

  • Plug in Crossover Cable (RJ45)

  • Restart your computer

  • Restart the device Pearpoint-PP350