Kummert Remote Interface
Question/Problem:
How do I have to proceed to launch the Kummer Remote Interface?
Answer/Solution:
Check your hardware environment:
2 USB-Serial converters OR just 1, in case the computer, where WinCan VX is installed, has got a built-in COM-port.
1 Null-Modem cable (crossed wires for pins 2 and 3)
Proceed as follows to install and configure the Kummert Profi3 system:
Connect a USB-Serial converter to the Profi3 system and install the drivers
Copy the software package WinCanKummertCamInterface.zip to the Profi3 system and unpack it to an empty folder.
Start WinCanKummertCamInterface.exe (requires DotNET 4)
Select the COM port of the USB-Serial converter
Press the button Initialize: no error message should pop up!
Activate the check box Auto Initialize to have the device initialized always at program launch.
Proceed as follows to configure the computer
Connect a USB-Serial converter to the computes and install the corresponding driver which is provided by the manufacturer.
Connect the serial port of the computer to the Profi3 system using the Null-Modem cable.
Make sure the latest updates for Windows 10 / Windows 11 (provided by Microsoft) have been downloaded and installed.
Install the latest version of WinCan VX (1.2023.14.1)
Configuration in WinCan VX
Run the command Home>Settings and select the category OSD
Hit the button Select Device and select the the entry Kummert – Profi3 Remote:
Right click inside the OSD panel and select the context menu command Config Mode to open the panel that provides all function buttons for the current device.
Drag the function button Device ctl panel into the OSD panel as illustrated below:
Hitting the button Device ctl panel finally opens the Kummert Control Panel:
Â