...
Page Contents
| Table of Contents | ||
|---|---|---|
|
...
Introduction
...
This page contains only special setup requirements for Rausch Latras hardware that are different from the settings described in this parent page.
...
Rausch Hardware Configuration
Run the command Home → Settings, go to the category OSD (text Generator) and select the device Visatec-WKI as well as the corresponding COM-port:
...
Next switch to the category 3D Measurement and reselect the same device. The equipment from Rausch works without activation of any additional option (1):
...
A built-in compass gadget allows the user to get the camera crawler precisely orientated to North.
Finally confirm all settings and restart WinCan VX.
Once the configurations are set correctly and the geo-sensor is properly recognised, WinCan VX automatically opens the 3D measurement wizard in a separate panel.
...