...
| Table of Contents | ||
|---|---|---|
|
...
Introduction
This page contains only special setup requirements for iBak 3DGS hardware that are different from the settings described in this parent page.
...
iBak Hardware Configuration
Run the command Home → Settings, go to the category OSD (text Generator) and select the device EDE 7 as well as the corresponding COM-port (1):
...
Next switch to the category 3D Measurement, reselect the same device and activate the option Select start direction. Select another COM-port (e.g. COM2 or COM3).
...
| Note |
|---|
Important: in case the virtual device IBAK-SoftControl has been installed, you must select this one in the category Live-Video, OSD as well as 3D Measurement. |
The option Show button for hydrostatic measurement is only used in case you are asked to provide accurate measurements of the manhole altitudes (i.e. altitude above sea level of the manhole bottom).
Finally confirm all settings and restart WinCan VX.
Once the configurations are set correctly and the geo-sensor is properly recognised, WinCan VX automatically opens the 3D measurement wizard in a separate panel.
...