...
| Table of Contents | ||
|---|---|---|
|
...
Introduction
The geo-sensor provides reliable measurement data regarding the pipeline geometry so you can directly transfer them to your end customer (engineer office, local water authorities etc.).
...
Adjusting the Position of Objects
In some specific cases you will probably have to slightly move or rotate the whole geometry of a section (i.e. main pipe and linked laterals) in WinCan Map according to the background plot. Proceed as follows to do so:
...
Mind that both tools can only be applied to the currently selected section.
...
Update 3D Projects from VX v14 → v15
Following major changes to the WinCan VX application for 3D Measurements between versions14 and 15, there is a need to run an update to the data in some cases.
| Note |
|---|
This only needs to be done once on a project. This only needs to be dine on 3D projects that were created and started in VX v14 and are now being used in VX v15. |
Open the project in WinCan VX.
Close WinCan Map and WinCan 3D desktop application.
Be sure to be logged into VX as Admin user, so that the Admin ribbon bar is visible.
Select the tool from this menu option and let it run. It may take some time to complete if the project is large. Please have patience and let it complete.
...