Back to Inclination Measurements

Sections

Data Tab

The Data tab is an area for miscellaneous data processing functions. At the time of writing this, there is only one option which is the ‘Reprocess’ button and after it has been clicked, the user can then ‘Restore’ the data back to where it was before being reprocessed.

Open

This button fixes problems with inclination tests from much older versions of WinCan VX. In these old versions, the data points were always collected during the test regardless of which way the camera was travelling. So if you test was driving forwards and maybe there was some debris in the pipe and you shunted the camera backwards and forwards to get past it then you would get a zig-zag line in the middle of the curve and bad data points. The ‘Reprocess’ buttons gets rid of points recorded where the camera is travelling in the wrong direction.

This problem dos not exist in the more recent versions of WinCan VX since mid 2018 because the data points are simply not recorded when the camera is travelling the wrong direction.

There may be future possible controls introduced into this tab, but none are planned at the time of writing this.